709 Old Milford Rd

The address the driller recorded when the well was constructed. It may differ from today's address. "Lot 11, BR N 2" is an older land reference used before street addresses.

Well tag

A183193

The number on the metal tag attached to the wellhead.

This page is based on one provincial well record filed near this location. The same property may have more than one.This page shows one well record. The property may have others.

See this well and its neighbours on the map →

Well log diagram

Soil and rock layers, from the surface down, with the colours recorded.

Depth	Material	Colour
0 - 0.2 m 0 - 0 ft	Topsoil	Black
0.2 - 1.5 m 0 - 5 ft	Clay, Rock	Brown
1.5 - 5.5 m 5 - 18 ft	Limestone	Blue

Flow rate

19.8 GPM

90 LPM

The rate the driller recommended running a pump at, written on the well record when the well was constructed. Not a measurement of today's flow. GPM is imperial gallons per minute; LPM is litres per minute.

Well Depth

18 ft

5.5 m

How far down the hole goes, from the surface to the bottom.

Dug into

Bedrock

solid rock

Whether the hole ends in solid rock or the loose material above it.

Location accuracy

30 m - 100 m

how far the map dot could be off

The province's rating of how far the map dot may be from the well.

Year dug

2018

The year the well was finished.

Status of well

Water Supply

Well use: Domestic

Water

Water level	1.6 m (5 ft) below ground How far down the water sits in the well with the pump off, measured from the surface. It can rise and fall with the seasons.
Water found at depth	3 m (10 ft) - Fresh Depths where the driller found water, and the kind of water the driller marked on the form. 'Untested' means the driller did not check what kind of water it was.
Is the well flowing	Not recorded If the groundwater level is above the ground surface, water can flow out on its own, without a pump.

The pump test on this record

The driller pumped this well at 128.7 GPM (585 LPM) for 60 minutes.

A controlled test the driller ran when the well was constructed. These results do not show today's flow.

Water level before pumping	1.6 m (5 ft) below ground How far down the water sat in the well before the test began. The same resting level shown above.
Water level at the end of the test	3.8 m (12 ft) below ground How far down the water stood when the test ended, after the pumping drew it down.
How long the pumping test ran	60 minutes How long the test lasted.

Construction

Drilling method	Digging How the hole was made.
Completion	Not recorded How the bottom of the well was finished to let water in.
Surface seal	Clay 20, 0 - 2.5 m (0 - 8 ft) Material around the outside of the casing, near the ground. It helps keep surface water out.

Casing is the pipe lining the hole. It keeps the hole open and keeps loose ground and surface water out.

Casing	Depth	Diameter
Concrete	0 - 5.5 m (0 - 18 ft)	90 cm (35 in)

Screen details: Not recorded

The full record

Original record (PDF) How to read a well record - plain-English guide Back to the map

Opens the province's copy. Not every well has one.