393 County Rd 19

The address the driller recorded when the well was constructed. It may differ from today's address. "Lot 80, 3" is an older land reference used before street addresses.

Well tag

A008489

The number on the metal tag attached to the wellhead.

This page is based on one provincial well record filed near this location. The same property may have more than one.This page shows one well record. The property may have others.

See this well and its neighbours on the map →

Well log diagram

Soil and rock layers, from the surface down, with the colours recorded.

Depth	Material	Colour
0 - 1.1 m 0 - 4 ft	Silt, Sand, Gravel	Brown
1.1 - 19.8 m 4 - 65 ft	Limestone, Layered	Grey

Flow rate

Not recorded

The rate the driller recommended running a pump at, written on the well record when the well was constructed. Not a measurement of today's flow. GPM is imperial gallons per minute; LPM is litres per minute.

Well Depth

65 ft

19.8 m

How far down the hole goes, from the surface to the bottom.

Drilled into

Bedrock

solid rock

Whether the hole ends in solid rock or the loose material above it.

Location accuracy

30 m - 100 m

how far the map dot could be off

The province's rating of how far the map dot may be from the well.

Year drilled

2005

The year the driller finished the well.

Status of well

Observation Well

Well use: Not recorded

Water

Water level	Not recorded How far down the water sits in the well with the pump off, measured from the surface. It can rise and fall with the seasons.
Water found at depth	19 m (62 ft) - Fresh Depths where the driller found water, and the kind of water the driller marked on the form. 'Untested' means the driller did not check what kind of water it was.
Is the well flowing	Not recorded If the groundwater level is above the ground surface, water can flow out on its own, without a pump.

The pump test on this record

No pump test is recorded for this well.

Construction

Drilling method	Air Percussion How the hole was made.
Completion	Plastic Screen How the bottom of the well was finished to let water in.
Surface seal	Neat cement slurry, 0 - 0.3 m (0 - 1 ft) Bentonite slurry, 0.3 - 16.5 m (1 - 54 ft) Material around the outside of the casing, near the ground. It helps keep surface water out.

Casing is the pipe lining the hole. It keeps the hole open and keeps loose ground and surface water out.

Casing	Depth	Diameter
Plastic	0 - 16.8 m (0 - 55 ft)	5 cm (2 in)

Screen	Depth	Slot
Plastic	16.8 - 19.8 m (55 - 65 ft)	10

The full record

Original record (PDF) How to read a well record - plain-English guide Back to the map

Opens the province's copy. Not every well has one.